Innovate Eco-friendly building material, Create sunshine life.

UNQ

Precautions for plexiglass processing

by:UNQ     2021-03-22
1. Plexiglass processing Put the two plexiglass plates that need to be connected horizontally on the operating platform to close together, then stick a tape on the bottom, leaving a gap less than 0.3mm wide, and then use a syringe to slowly evenly uniform the adhesive from one side Inject the ground from the gap and fill it up completely, and then remove the tape after it is completely cured.  2, bonding facade bonding is the most widely used bonding technology. During the processing of plexiglass, the surface to be bonded should be wiped clean first. The plexiglass board with a thickness of 3mm can be bonded with thin metal wires. The bonding is completed by capillary action, and the metal wires are drawn out before the adhesive is cured.

  3. A ninety-degree angle profile must be used for inclined surface bonding to effectively prevent the displacement of the adhered surface. The adhesive should be applied slowly and evenly, and the profile can be removed after it is completely cured.  4. Plane bonding is a special bonding method. The surface to be adhered is wiped clean and placed horizontally, and then an appropriate amount of adhesive is poured on the surface. Put one side of another plexiglass board diagonally in contact with the board to be coated with adhesive, and then put it down evenly and slowly to drive out the air bubbles from one side to complete the bonding.

Custom message
暂无友情链接数据
Chat Online
Chat Online
Chat Online inputting...
Sign in with: