In the construction industry, the use of various boards is very necessary, and boards are also one of the important building materials. With the development of the industry, the requirements for materials in the construction industry continue to increase, and the performance of boards is also undergoing major changes. , For example, PC diffuser plate is the case, then what is the specific use of this plate? How to maintain it during use? Let's see the detailed introduction. How to use and maintain the PC diffuser: Before use, please pay attention to the side with the protective film mark outward. The protective film cannot be removed before use, because its existence can avoid the process of product transportation and installation. The medium is scratched; when installing, use a neutral sealant, and carefully check whether it is compatible with the board before use, and the colloid must not have acid or alkali.
If you need to drill a hole on the product when you use it, you need to drill a small hole first, and then slowly expand it to the required size, and you must pay attention to the size of the hole and the edge when drilling. Less than 40 mm, the diameter of the hole must be up to the standard, otherwise it will be affected by thermal expansion and contraction; when placing it, you must be careful not to cover it or stack it, because doing so will cause the equipment to expand and contract. At that time, a large internal stress is generated, which causes the plate to burst or crack. In the process of plate transportation, you must not put it on the plate at noon, nor use sharp objects to collide with the plate. When loading and unloading the coil, you will use machinery or use the vehicle springboard. When unloading, you must pay attention to protecting the plate and placing it. It must not be exposed to the outdoors at the time, but should be placed in a cool place; when cleaning the board, it should be done in a small area, the water temperature should not be too high or too low, pay attention to rinse with warm water, and then wipe off the surface dust with soft tissue. When cleaning, you must pay attention not to sand or use strong alkali to clean, and do not wipe the surface with a dry cloth or hard brush, otherwise there will be roughness. This is the introduction of the PC diffuser. In the process of use, effective guarantee methods can improve the performance of the product, and the maintenance during use can extend the service life of the product. These are the conditions that reflect the value of the product, so everyone Be sure to pay special attention. If you want to buy high-quality plates, you can go to Haoxin.